Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 250
reset stack-unit, Dell#01:02:00: %STKUNIT0-M:CP %CHMGR-5-STACKUNIT_RESET: Stack
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
This command is used to reset the stack-unit. The master unit can also be power cycled using this command. reset stack-unit Reset any designated stack member except the management unit (master unit). Syntax Parameters reset stack-unit 0-5 hard 0-5 hard Enter the stack member unit identifier of the stack member to reset. Reset the stack unit if the unit is in a problem state. Defaults Command Modes Command History none EXEC Privilege Version 9.6. (0.0) Supported on the FN I/O Aggregator. Usage Information This command is supported on the FN410S and the FN410T Aggregators Resetting the management unit is not allowed and an error message displays if you try to do so. Resetting is a soft reboot, including flushing the forwarding tables. You can run this command directly on the stack standby unit (Standby Master) to reset the standby. You cannot reset any other unit from the standby unit Example Dell#show system brief Stack MAC : 00:1e:c9:f1:00:9b -- Stack Info -- Unit UnitType Status ReqTyp CurTyp Version Ports --- 0 Management online I/O-Aggregator I/O- Aggregator 8-3-17-46 56 1 Standby online I/O-Aggregator I/O- Aggregator 8-3-17-46 56 2 Member not present 3 Member not present 4 Member not present 5 Member not present Dell# Dell#reset stack-unit 0 >>>Resetting master not allowed % Error: Reset of master unit is not allowed. Dell# Dell#reset stack-unit 1 Dell#01:02:00: %STKUNIT0-M:CP %CHMGR-5-STACKUNIT_RESET: Stack unit 1 being reset 250