Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 379
disable, hello, multiplier
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 379 highlights
disable Enable or disable LLDP. Syntax disable To enable LLDP, use the no disable command. Defaults Command Modes Command History Related Commands Enabled, that is no disable. CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. debug lldp interface - debugs LLDP. hello Configure the rate at which the LLDP control packets are sent to its peer. Syntax hello seconds To revert to the default, use the no hello seconds command. Parameters seconds Enter the rate, in seconds, at which the control packets are sent to its peer. The rate is from 5 to 180 seconds. The default is 30 seconds. Defaults Command Modes Command History 30 seconds CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. multiplier Set the number of consecutive misses before LLDP declares the interface dead. Syntax multiplier integer To return to the default, use the no multiplier integer command. Parameters integer Enter the number of consecutive misses before the LLDP declares the interface dead. The range is from 2 to 10. 379