Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 447
debug uplink-state-group, uplink-state, group, Defaults, Command, Modes, History, Version 9.40.0
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 447 highlights
Defaults Command Modes Command History Related Commands Where port-range and port-channel-range specify a range of ports separated by a dash (-) and/or individual ports/port channels in any order; for example: tengigabitethernet 1/1-2,5,9,11-12 portchannel 1-3,5. A comma is required to separate each port and port-range entry. uplink-stategroup group-id Re-enables all UFD-disabled downstream interfaces in the group. The valid group-id values are from 1 to 16. A downstream interface in a UFD-disabled uplink-state group is also disabled and is in a UFD-Disabled Error state. CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. • downstream - assigns a port or port-channel to the uplink-state group as a downstream interface. • uplink-state-group - creates an uplink-state group and enables the tracking of upstream links. debug uplink-state-group Enable debug messages for events related to a specified uplink-state group or all groups. Syntax debug uplink-state-group [group-id] To turn off debugging event messages, enter the no debug uplink-stategroup [group-id] command. Parameters group-id Enables debugging on the specified uplink-state group. The valid group-id values are from 1 to 16. Defaults Command Modes Command History none EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Related Commands clear ufd-disable - re-enables downstream interfaces that are in a UFD-Disabled Error state. 447