Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 422
Related, Commands, Syntax, Parameters, unit number, programmable, stack, Defaults, Modes, History
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 422 highlights
Related Commands power-cycle stack-unit-resets the designated stack member. show diag- displays the data plane or management plane input and output statistics of the designated component of the designated stack member. show system-displays the current status of all stack members or a specific member. stack-unit iom-mode Toggle the FN I/O Aggregator operating mode between programmable multiplex, stand-alone, stack, and VLT modes. Syntax stack-unit iom-mode [programmable-mux | stack | standalone | vlt] Parameters unit number Enter the number of the member stack unit. The range is from 0 to 5. programmable -mux Enable programmable multiplex mode. stack Enable stack mode. standalone Enable stand-alone mode. vlt Enable virtual link trunking mode. Defaults Command Modes Command History standalone • CONFIGURATION Version 9.6. (0.0) Supported on the FN I/O Aggregator. Usage Information Example Related Commands This command is supported on the FN410S and the FN410T Aggregators. Dell(conf)#stack-unit 0 iom-mode stack % You are about to stack your IOA module, please reload the IOA and then plug in the stacking cable for the changes to take effect. Dell(conf)# Dell# reload- Reboots the operating system. show system- displays the current status of all stack members or a specific member. 422