Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 206
source (port monitoring), Syntax, Parameters, destination, direction {rx | tx, both}, Defaults
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 206 highlights
show monitor session - displays a monitor session. source (port monitoring) Configure a port monitor source. Syntax source interface destination interface direction {rx | tx | both} To disable a monitor source, use the no source interface destination interface direction {rx | tx | both} command. Parameters interface Enter the one of the following keywords and slot/port information: • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. destination direction {rx | tx | both} Enter the keyword destination to indicate the interface destination. Enter the keyword direction followed by one of the packet directional indicators. • rx: to monitor receiving packets only. • tx: to monitor transmitting packets only. • both: to monitor both transmitting and receiving packets. Defaults Command Modes Command History Example Usage Information none MONITOR SESSION (conf-mon-sess-session-ID) Version 9.4(0.0) Supported on the FN I/O aggregator. Dell(conf-mon-sess-11)#source tengig 0/1 destination tengig 0/8 direction rx Dell(conf-mon-sess-11)# The monitored (source) interface must be a server-facing interface in the format slot/port, where valid slot number is 0 and server-facing port numbers are from 1 to 8. 206