Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 348
interface ManagementEthernet, TenGigabitEthernet, shutdown, Port Channel Commands
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 348 highlights
Defaults Command Modes Command History Usage Information Example Related Commands • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. Not configured. CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. You cannot delete a physical interface. By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface in mode, ensure that the interface's configuration does not contain an IP address and enter the Port Channel Commands command. The tunnel interface operates as an ECMP (equal cost multi path) only when the next hop to the tunnel destination is over a physical interface. If you select any other interface as the next hop to the tunnel destination, the tunnel interface does not operate as an ECMP. Dell(conf)#interface tengig 0/1 Dell(conf-if-te-0/1)#exit# interface port-channel - configures a port channel. interface vlan - configures a VLAN. interface ManagementEthernet Configure the Management port on the system. Syntax Parameters interface ManagementEthernet slot/port slot/port Enter the keyword ManagementEthernet, then the slot number (0) and port number zero (0). Defaults Command Modes Command History Not configured. CONFIGURATION 9.4.(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Usage Information You cannot delete a Management port. 348