Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 441
Command, Modes, History, Version 9.40.0, Syntax, Parameters, Defaults, Usage, Information, Related
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 441 highlights
Command Modes Command History CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. logging source-interface Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog server. Syntax logging source-interface interface To disable this command and return to the default setting, use the no logging source-interface command. Parameters interface Enter the following keywords and slot/port or number information: • For the management interface on the RPM, enter the keyword ManagementEthernet then the slot/port information. The slot range is 0 and the port range is 0. • For a Port Channel interface, enter the keywords portchannel then a number. The range is from 1 to 128. • For a Ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For VLAN interface, enter the keyword vlan then a number from 1 to 4094. Defaults Command Modes Command History Not configured. CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Usage Information Related Commands Syslog messages contain the IP address of the interface used to egress the router. By configuring the logging source-interface command, the Syslog packets contain the IP address of the interface configured. logging - enables logging to the Syslog server. show logging Display the logging settings and system messages logged to the internal buffer of the switch. Syntax show logging [number | history [reverse][number] | reverse [number] | summary] 441