Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 148
show interfaces, Syntax, Parameters, Command, Modes, History, Version 9.40.0, Usage, Information
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
show interfaces Displays information on a specific physical interface or virtual interface. Syntax Parameters show interfaces interface interface Enter one of the following keywords and slot/port or number information: • For the management interface on the stack-unit, enter the keyword managementethernet followed by slot/ port information. The slot and port range is 0. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. • For a Port Channel interface, enter the keyword portchannel followed by a number. The range is from 1 to 128. Command Modes Command History Usage Information User Information • EXEC • EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. Use this show interfaces command for details on a specific interface. Use the show interfaces stack-unit command for details on all interfaces on the designated stack unit. On the I/O Aggregator, the show interface output displays incorrect rate information details over time for link monitoring when the rate-interval is configured for 5 seconds. Dell Networking recommends using higher rate-intervals such as 15 to 299 seconds to minimize the errors seen. NOTE: In the CLI output, the power value will be rounded to a 3-digit value. For receive/transmit power that is less than 0.000, an snmp query will return the corresponding dbm value even though the CLI displays as 0.000. NOTE: After the counters are cleared, the line-rate continues to increase until it reaches the maximum line rate. When the maximum line rate is reached, there will be no change in the line-rate. The following describes the show interfaces command shown in the 10G example below. Line TenGigabitEthern et 0/0... Description Displays the interface's type, slot/port, and administrative and line protocol status. 148