Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 350
Example Bulk, Example, Multiple Ports, Overlapping, Ports, Usage, Information, Example Single, Range
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 350 highlights
• The interface range prompt includes interface types with slot/port information for valid interfaces. The prompt allows for a maximum of 32 characters. If the bulk configuration exceeds 32 characters, it is represented by an ellipsis ( ... ). • When the interface range prompt has multiple port ranges, the smaller port range is excluded from the prompt. • If overlapping port ranges are specified, the port range is extended to the smallest start port and the biggest end port. Example (Bulk) Example (Multiple Ports) Example (Overlapping Ports) Usage Information Example (Single Range) Example (Multiple Range) Related Commands Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/4 , tengig 0/7 , fa 0/0 % Warning: Non-existing ports (not configured) are ignored by interface-range Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/3 - 5 Dell(conf-if-range-te-0/1-5)# Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/1 - 5 Dell(conf-if-range-te-0/1-5)# Only VLAN and port-channel interfaces created using the interface vlan and interface port-channel commands can be used in the interface range command. Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-channel interfaces that are not displayed in the show running-config command cannot be used with the bulk configuration feature of the interface range command. You cannot create virtual interfaces (VLAN, Port-channel) using the interface range command. NOTE: If a range has VLAN, physical, port-channel, and SONET interfaces, only commands related to physical interfaces can be bulk configured. To configure commands specific to VLAN or port-channel, only those respective interfaces should be configured in a particular range. This example shows a single range bulk configuration. Dell(conf)# interface range tengigabitethernet 0/1 - 5 Dell(conf-if-range-te-0/1-5)# no shutdown Dell(conf-if-range-te-0/1-5)# This example shows how to use commas to add VLAN, and port-channel interfaces to the range. Dell(conf-if)# interface range tengigabitethernet 0/1 - 5, vlan 2 - 10, port-channel 1 - 25 Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)# no shutdown Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)# interface port-channel - configures a port channel group. 350