Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 435
snmp-server enable traps, snmp-server host
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 435 highlights
• SNMP v3 informs are not currently supported with IPv6 addresses. • If you are using access control lists (ACLs) in an SNMP v3 configuration, group ACL overrides user ACL if the user is part of that group. • SNMP operations are not supported on a virtual local area network (VLAN). snmp-server enable traps Enable SNMP traps. Syntax snmp-server enable traps { snmp [linkdown | linkup] | stack} To disable traps, use the no snmp-server enable traps [notificationtype] [notification-option] command. Parameters snmp Enter the keyword snmp to enable SNMP traps. For the snmp traps, enter one of the following optional parameters: • linkdown - to enable linkdown trap. • linkup - to enable linkuptrap stack Enter the keyword stack to enable stacking role change traps. Defaults Command Modes Command History Not enabled. CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Usage Information Dell Networking OS supports up to 16 SNMP trap receivers. If you do not configure this command, no traps controlled by this command are sent. If you do not specify a notification-type and notification-option, all traps are enabled. snmp-server host Configure the recipient of an SNMP trap operation. Syntax snmp-server host ip-address | ipv6-address To remove the SNMP host, use the no snmp-server host ip-address command. Parameters ip-address Enter the keyword host then the IP address of the host (configurable hosts is limited to 16). 435