Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 140
interface vlan, Multiple Ports
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Example-Bulk Configuration Warning Message ExampleInterface Range prompt with Multiple Ports ExampleInterface Range prompt Overlapping Port Ranges Example-Single Range Bulk Configuration ExampleMultiple Range Bulk Configuration with VLAN and port channel Related commands Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/4 , tengig 0/7 , fa 0/0 % Warning: Non-existing ports (not configured) are ignored by interface-range Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/3 - 5 Dell(conf-if-range-te-0/1-5)# Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/1 - 5 Dell(conf-if-range-te-0/1-5)# Only VLAN and port-channel interfaces created using the interface vlan and vlan tagged commands can be used in the interface range command. Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-channel interfaces that are not displayed in the show running-config command cannot be used with the bulk configuration feature of the interface range command. You cannot create virtual interfaces (VLAN, Port-channel) using the interface range command. NOTE: If a range has VLAN, physical, and port-channel interfaces, only commands related to physical interfaces can be bulk configured. To configure commands specific to VLAN or port-channel, only those respective interfaces should be configured in a particular range. Dell(conf)# interface range tengigabitethernet 0/1 - 5 Dell(conf-if-range-te-0/1-5)# no shutdown Dell(conf-if-range-te-0/1-5)# The following example shows how to use commas to add VLAN and port-channel interfaces to the range. Dell(conf-if)# interface range tengigabitethernet 0/1 - 5, vlan 2 - 10, port-channel 1 - 25 Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)# no shutdown Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)# show config (from INTERFACE RANGE mode) - Shows the bulk configuration interfaces. show interfaces status - Displays a summary of interface information. interface vlan Configure the default VLAN to enable Static or DCHP IP configuration Syntax interface vlan def-vlan-id 140