Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 50
debug ifm trace-flags, Defaults, Command, Modes, History, Version 9.40.0, Usage, Information, Related
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Defaults Command Modes Command History Usage Information Related Commands Disabled EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. This command enables (and disables) the collection of CPU traffic statistics from the time this command is executed (not from system boot). However, excessive traffic a CPU receives automatically triggers (turn on) the collection of CPU traffic statics. To view the traffic statistics, use the show cpu-traffic-stats command. If the CPU receives excessive traffic, traffic is rate controlled. NOTE: You must enable this command before the show cpu-trafficstats command displays traffic statistics. Dell Networking recommends disabling debugging (no debug cpu-traffic-stats) after troubleshooting is complete. show cpu-traffic-stats - displays the cpu traffic statistics. debug ifm trace-flags Turn on the IFM internal trace-flags. Syntax debug ifm trace-flags trace-flags To disable this command, use the no debug ifm trace-flags command. Parameters trace-flags Enter a hexadecimal number representing the trace-flag. Defaults Command Modes Command History None EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. NOTE: Use this command only when you are working directly with a technical support representative to troubleshoot a problem. Do not use this command unless a technical support representative instructs you to do so. 50