Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 212

Parameters Defaults Command Modes Command History Undo a configuration with the no aaa authorization commands {level| {name|default} {local | tacacs+ | none} command. commands level name default local tacacs+ none Enter the keyword commands then the command privilege level for command level authorization. Define a name for the list of authorization methods. Define the default list of authorization methods. Use the authorization parameters on the system to perform authorization. Use the TACACS+ protocol to perform authorization. Enter the keyword none to apply no authorization. none CONFIGURATION This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.6. (0.0) Version 9.5(0.0) Version 9.2(1.0) Version 9.0.2.0 Version 8.3.19.0 Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.1.1.0 Supported on the FN I/O Aggregator. Added support for roles on the Z9000, S6000, S4820T, S4810, MXL Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Added support for RADIUS. aaa authorization config-commands Set parameters that restrict (or permit) a user's access to EXEC level commands. Syntax aaa authorization config-commands 212