Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 259
clock summer-time date, Defaults, Command, Modes, History, Version 9.40.0, Usage, Information, Example
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 259 highlights
Defaults Command Modes Command History Usage Information Example year Not configured. EXEC Privilege Enter a four-digit number as the year. The range is from 1993 to 2035. Version 9.4(0.0) Supported on the FN I/O aggregator. You can change the order of the month and day parameters to enter the time and date as time day month year . You cannot delete the software clock. The software clock runs only when the software is up. The clock restarts, based on the hardware clock, when the switch reboots. Dell Networking recommends using an outside time source, such as NTP, to ensure accurate time on the switch. Dell#clock set 12:11:00 21 may 2012 Dell# clock summer-time date Set a date (and time zone) on which to convert the switch to daylight saving time on a one-time basis. Syntax clock summer-time time-zone date start-month start-day startyear start-time end-month end-day end-year end-time [offset] To delete a daylight saving time zone configuration, use the no clock summertime command. Parameters time-zone start-month start-day start-year start-time Enter the three-letter name for the time zone. This name is displayed in the show clock output. Enter the name of one of the 12 months in English. You can enter the name of a day to change the order of the display to time day month year. Enter the number of the day. The range is from 1 to 31. You can enter the name of a month to change the order of the display to time day month year. Enter a four-digit number as the year. The range is from 1993 to 2035. Enter the time in hours:minutes. For the hour variable, use the 24-hour format; example, 17:15 is 5:15 pm. 259