Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 141
monitor interface, Parameters, Defaults, Command, Modes, History, Version 9.40.0, Usage, Information
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
Parameters Defaults Command Modes Command History Usage Information Example Related commands def-vlan-id Enter 1 for the default VLAN. Not configured CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is applicable only for the default VLAN. For all other VLANs, the following error message displays: Dell(conf)#int vlan 2 Error: Command allowed only for default Vlan. Dell(conf)# For more information about VLANs and the commands to configure them, refer to Virtual LAN (VLAN) Commands. Dell(conf)#int vlan 1 Dell(conf-if-vl-1)# show vlan - Displays the current VLAN configuration on the switch. vlan tagged - Adds a Layer 2 interface to a VLAN as a tagged interface. vlan untagged - Adds a Layer 2 interface to a VLAN as an untagged interface. monitor interface Monitor counters on a single interface or all interfaces on a stack unit. The screen is refreshed every five seconds and the CLI prompt disappears. Syntax monitor interface [interface] To disable monitoring and return to the CLI prompt, press the q key. Parameters interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For the management port, enter the keyword managementethernet followed by the slot (0) and the port (0). • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword portchannel followed by a number. The range is from 1 to 128. 141