Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 318
show stack-unit stack-ports ets details, Related, Commands, Syntax, Parameters, Modes, History
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 318 highlights
Related Commands dcb-map - creates a DCB map to configure PFC and ETS parameters and applies the PFC and ETS settings on Ethernet ports. show stack-unit stack-ports ets details Displays the ETS configuration applied to egress traffic on stacked ports, including ETS Operational mode on each unit and the configurated priority groups with dot1p priorities, bandwidth allocation, and scheduler type. Syntax Parameters show stack-unit {all | stack-unit} stack-ports {all | portnumber} ets details stack-unit port-number Enter the stack unit identification. Enter the port number. Command Modes Command History CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Example Dell(conf)# show stack-unit all stack-ports all ets details Stack unit 0 stack port all Max Supported TC Groups is 4 Number of Traffic Classes is 1 Admin mode is on Admin Parameters: Admin is enabled TC-grp Priority# Bandwidth TSA 0 0,1,2,3,4,5,6,7 100% ETS 1 - - 2 - - 3 - - 4 - - 5 - - 6 - - 7 - - 8 - - Stack unit 1 stack port all Max Supported TC Groups is 4 Number of Traffic Classes is 1 Admin mode is on Admin Parameters: Admin is enabled TC-grp Priority# Bandwidth TSA 0 0,1,2,3,4,5,6,7 100% ETS 1 - - 2 - - 3 - - 318