Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 235

ssh Open an SSH connection specifying the host name, username, port number and version of the SSH client. Dell Networking OS supports both inbound and outbound SSH sessions using IPv4 addressing. Inbound SSH supports accessing the system through the management interface as well as through a physical Layer 3 interface. Syntax Parameters ssh {hostname | ipv4 address} [-| username | -p port-number|-v {1|2}] hostname ipv4 address -l username -p portnumber -v {1 | 2} (OPTIONAL) Enter the IP address or the host name of the remote device. (OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D. (OPTIONAL) Enter the keyword -l followed by the user name used in this SSH session. The default is the user name of the user associated with the terminal. (OPTIONAL) Enter the keyword -p followed by the port number. The range is from 1 to 65536. The default is 22. (OPTIONAL) Enter the keyword -v then the SSH version 1 or 2. The default is the version from the protocol negotiation. Defaults Command Modes Command History Example As shown in the Parameters section. EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. Dell#ssh 123.12.1.123 -l ashwani -p 5005 -v 2 username Establish an authentication system based on user names. Syntax username name [nopassword | {password | secret} [encryptiontype] password] [privilege level] If you do not want a specific user to enter a password, use the nopassword option. To delete authentication for a user, use the no username name command. Parameters name Enter a text string for the name of the user up to 63 characters. 235