Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 452
uplink-state-group
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 452 highlights
Command Modes Command History Example Related Commands • EXEC • EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Dell#show uplink-state-group detail (Up): Interface up (Dwn): Interface down (Dis): Interface disabled Uplink State Group : 1 Status: Enabled, Up Defer Timer : 10 sec Upstream Interfaces : Po 128(Up) Downstream Interfaces : Te 0/1(Dwn) Te 0/2(Dwn) Te 0/3(Up) Te 0/4(Dwn) Te 0/5(Up) Te 0/6(Dwn) Te 0/7(Up) Te 0/8(Up) Dell# • show running-config uplink-state-group - displays the current configuration of one or more uplink-state groups. • uplink-state-group - create an uplink-state group and enables the tracking of upstream links. uplink-state-group Create an uplink-state group and enable the tracking of upstream links on a switch/ router. Syntax uplink-state-group group-id To delete an uplink-state group, enter the no uplink-state-group group-id command. Parameters group-id Enter the ID number of an uplink-state group. The range is from 1 to 16. Defaults Command Modes Command History none CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Usage Information After you enter the command, to assign upstream and downstream interfaces to the group, enter Uplink-State-Group Configuration mode. An uplink-state group is considered to be operationally up if at least one upstream interface in the group is in the Link-Up state. 452