Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 424
stack-unit priority, stack-unit renumber
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 424 highlights
Related Commands | Pipe through a command Dell#show system stack-unit 0 stack-group configured Configured stack groups in stack-unit 0 Dell#show system stack-unit 0 stack-group Stack group Ports 0 0/9 1 0/10 2 0/11 3 0/12 Dell# reload- reboots the system. show system- displays the current status of all stack members or a specific member. stack-unit priority Configure the ability of a switch to become the management unit of a stack. Syntax Parameters stack-unit stack-number priority 1-14 stack-number Enter the stack member unit identifier. 1-14 This preference parameter allows you to specify the management priority of one backup switch over another, with 0 the lowest priority and 14 the highest. The switch with the highest priority value is chosen to become the management unit if the active management unit fails or on the next reload. Defaults Command Modes Command History 0 CONFIGURATION Version 9.6. (0.0) Introduced on the FN I/O Aggregator. Usage Information Related Commands This command is supported on the FN410S and the FN410T Aggregators. • reload - reboots Dell Networking Operating System (OS). • show system - displays the status of all stack members or a specific member. stack-unit renumber Change the stack member ID of any stack member or a stand-alone unit. Syntax stack-unit 0-5 renumber 0-5 424