Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 145
negotiation auto - server manual
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
negotiation auto Enable auto-negotiation on an interface. Syntax negotiation auto To disable auto-negotiation, enter no negotiation auto command. Defaults Command Modes Command History Usage Information Enabled. INTERFACE Version 9.4(0.0) Supported on the FN I/O aggregator. The no negotiation auto command is only available if you first manually set the speed of a port to 10Mbits or 100Mbits. Example (Configured) User Information Dell#show interfaces configured TenGigabitEthernet 0/1 is up, line protocol is up Hardware is DellEth, address is 00:1e:c9:de:04:9c Current address is 00:1e:c9:de:04:9c Server Port AdminState is N/A Pluggable media not present Interface index is 33886978 Internet address is not set Mode of IPv4 Address Assignment : NONE DHCP Client-ID :001ec9de049c MTU 12000 bytes, IP MTU 11982 bytes LineSpeed 10000 Mbit Flowcontrol rx on tx off ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 03:56:48 Queueing strategy: fifo Input Statistics: Both sides of the link must have auto-negotiation enabled or disabled for the link to come up. The following details the possible speed and auto-negotiation combinations for a line between two 10/100/1000 Base-T Ethernet interfaces. Port 0 • auto-negotiation enabled* speed 1000 or auto • auto-negotiation enabled speed 100 • auto-negotiation disabled speed 100 • auto-negotiation disabled speed 100 • auto-negotiation enabled* speed 1000 or auto Port 1 • auto-negotiation enabled* speed 1000 or auto • auto-negotiation enabled speed 100 145