Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 164
vlan tagged (CMC), Parameters, Defaults, Command, Modes, History, Version 9.40.0, Usage, Information
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
Parameters Defaults Command Modes Command History Usage Information Related Commands interface none EXEC Enter the keyword TenGigabitEthernet followed by the slot/port information for the 100/1000/10GBase-T Ethernet interface. Version 9.4(0.0) Supported on the FN I/O aggregator. The interface must be enabled to run the test or an error message is generated: Dell#tdr-cable-test tengigabitethernet 0/2 %Error: Interface is disabled TenGIG 0/2 show tdr - Displays the results of the TDR test. vlan tagged (CMC) Add a Layer 2 interface to a VLAN as a tagged interface. Syntax vlan tagged [vlan-id] To remove a tagged interface from a VLAN, use the no vlan tagged vlan-id command. Parameters vlan-id Enter the VLAN ID. The range is from 1 to 4094. Defaults Command Modes Command History Usage Information All interfaces in Layer 2 mode are untagged. INTERFACE Version 9.4(0.0) Supported on the FN I/O aggregator. If the interface belongs to several VLANs, you must remove it from all VLANs to change it to an untagged interface. Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong to one VLAN at a time. When two or more ports configured for VLANs form a LAG, the resulting LAG is a tagged member of all the configured VLANs and an untagged member of the VLAN to which the port with the lowest port ID belongs. 164