Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 351
interface vlan, intf-type cr4 autoneg, Syntax, Parameters, Defaults, Command, Modes, History
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 351 highlights
interface vlan - configures a VLAN interface. interface vlan Configure a VLAN. You can configure up to 4094 VLANs. Syntax interface vlan vlan-id To delete a VLAN, use the no interface vlan vlan-id command. Parameters Defaults Command Modes Command History Usage Information vlan-id Enter a number as the VLAN Identifier. The range is from 1 to 4096. Not configured, except for the Default VLAN, which is configured as VLAN 1. CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. For more information about VLANs and the commands to configure them, refer to the Virtual LAN (VLAN) Commands. FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC/IP ACLs are not supported. Example Related Commands Dell(conf)#int vlan 3 Dell(conf-if-vl-3)# interface - configures a physical interface. interface port-channel - configures a port channel group. intf-type cr4 autoneg Set the interface type as CR4 with auto-negotiation enabled. Syntax intf-type cr4 autoneg If you configure intf-type cr4 autoneg, use the no intf-type cr4 autoneg command to set the interface type as cr4 with autonegotiation disabled. Defaults Command Modes Command History Not configured CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. 351