Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 380
NPIV Proxy Gateway, dcb-map
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 380 highlights
Defaults Command Modes Command History 4 x hello CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. NPIV Proxy Gateway The N-port identifier virtualization (NPIV) Proxy Gateway (NPG) feature provides FCoE-FC bridging capability on the FN 2210S Aggregator, allowing server CNAs to communicate with SAN fabrics over the FN 2210S Aggregator. To configure the FN 2210S I/O Aggregator to operate as an NPIV proxy gateway, use the following commands: dcb-map Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface. I/O Aggregator Syntax Parameters dcb-map map-name map-name Enter a DCB map name. The maximum number of alphanumeric characters is 32. Defaults Command Modes None. There are no pre-configured PFC and ETS settings on S5000 Ethernet interfaces. CONFIGURATION INTERFACE Command History Usage Information Version 9.4(0.0) Supported on the FN I/O aggregator. A DCB map is a template used to configure DCB parameters and apply them on converged Ethernet interfaces. DCB parameters include priority-based flow control (PFC) and enhanced traffic selection (ETS). To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map command. Use the dcb-map command to create a DCB map to specify PFC and ETS settings and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is enabled on Ethernet ports by default. 380