Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 185
Isolated Networks, io-aggregator isolated-network vlan
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
Isolated Networks This chapter describes the isolated networks commands in the Dell Networking OS. 15 io-aggregator isolated-network vlan Enable the isolated-network functionality for a particular VLAN or a set of VLANs. Syntax Parameters [no] io-aggregator isolated-network vlan vlan-range isolatednetwork vlan vlanrange Specify an isolated network to be configured Enter the keyword vlan followed by the member VLANs using VLAN IDs (separated by commas), a range of VLAN IDs (separated by a hyphen), a single VLAN ID, or a combination. For example: VLAN IDs (comma-separated): 3, 4, 6. Range (hyphen-separated): 5-10. Combination: 3, 4, 5-10, 8. Defaults Command Modes Usage Information Command History Example Not configured. CONFIGURATION To add more VLANs into an isolated network, you can enter this same command at any later point. The VLANs specified are appended to the existing set of VLANs. To remove a VLAN or a set of VLANs from an isolated network, use the no form of command. Version 9.5(0.0) Supported on the FN I/O aggregator. Dell(conf)#io-aggregator isolated-network vlan 5-10 show io-aggregator isolated-networks Display the VLANs that are configured to be part of an isolated network on an Aggregator. Syntax show io-aggregator isolated-networks 185