Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 271
clear hardware stack-unit, diag stack-unit, inspection of the rear modules. The numbering is
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 271 highlights
clear hardware stack-unit Clear statistics from selected hardware components. Syntax Parameters clear hardware stack-unit 0-5 {counters | unit 0-1 counters | cpu data-plane statistics | stack-port 9-12} stack-unit 0-5 Enter the keywords stack-unit then 0 to 5 to select a particular stack member and then enter one of the following command options to clear a specific collection of data. counters unit 0-0 counters Enter the keyword counters to clear the counters on the selected stack member. Enter the keyword unit along with a port-pipe number, from 0 to 1 , then the keyword counters to clear the counters on the selected port-pipe. cpu data-plane statistics stack-port 9- 12 Enter the keywords cpu data-plane statistics to clear the data plane statistics. Enter the keywords stack-port then the port number of the stacking port to clear the statistics of the particular stacking port. The range is from 9 to 12. NOTE: You can identify stack port numbers by physical inspection of the rear modules. The numbering is the same as for the 10G ports. You can also inspect the output of the show system stack-ports command. Defaults Command Modes Command History Related Commands none EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. show diag - displays the data plane or management plane input and output statistics of the designated component of the designated stack member. diag stack-unit Run offline diagnostics on a stack unit. Syntax Parameters diag stack-unit number {alllevels | level0 | level1 | level2 [verbose no-reboot]| terminate| interactive test } number alllevels Enter the stack-unit number. The range is from 0 to 5. Enter the keyword alllevels to run the complete set of offline diagnostic tests. 271