Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 111
Command, Modes, History, Version 9.40.0, Usage, Information, Field, Description, State, PFC Mode
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Command Modes Command History Usage Information Example Related Commands • EXEC • EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and priority-based flow control (PFC) parameters used to configure server-facing Ethernet ports. The following table describes the show qos dcb-map output shown in the example below. Field State PFC Mode PG TSA BW PFC Priorities Description Complete: All mandatory DCB parameters are correctly configured. In progress: The DCB map configuration is not complete. Some mandatory parameters are not configured. PFC configuration in DCB map: On (enabled) or Off. Priority group configured in the DCB map. Transmission scheduling algorithm used by the priority group: Enhanced Transmission Selection (ETS). Percentage of bandwidth allocated to the priority group. PFC setting for the priority group: On (enabled) or Off. 802.1p priorities configured in the priority group. Dell# show qos dcb-map dcbmap2 State :Complete PfcMode:ON PG:0 TSA:ETS BW:50 PFC:OFF Priorities:0 1 2 4 5 6 7 PG:1 TSA:ETS BW:50 PFC:ON Priorities:3 dcb-map - creates a DCB map to configure PFC and ETS parameters and applies the PFC and ETS settings on Ethernet ports. 111