Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 413
ip radius source-interface, ip tacacs source-interface
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 413 highlights
Related Commands banner exec- configures a banner to display when entering EXEC mode. line - enables and configures console and virtual terminal lines to the system. ip radius source-interface Specify an interface's IP address as the source IP address for RADIUS connections. Syntax ip radius source-interface interface To delete a source interface, use the no ip radius source-interface command. Parameters interface Enter the following keywords and slot/port or number information: • For a Port Channel interface, enter the keywords portchannel then a number. The range is from 1 to 128. • For a ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For VLAN interface, enter the keyword vlan then a number from 1 to 4094. Defaults Command Modes Command History Not configured. CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. ip tacacs source-interface Specify an interface's IP address as the source IP address for TACACS+ connections. Syntax ip tacacs source-interface interface To delete a source interface, use the no ip tacacs source-interface command. Parameters interface Enter the following keywords and slot/port or number information: • For a Port Channel interface, enter the keywords portchannel then a number. The range is from 1 to 128. • For a ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For VLAN interface, enter the keyword vlan then a number from 1 to 4094. 413