Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 361
Internet Group Management Protocol (IGMP), IGMP Commands
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 361 highlights
links before it can be declared as up. For example, if the required minimum is four, and only three are up, the LAG is considered down. Internet Group Management Protocol (IGMP) The IGMP commands are supported by the Dell Networking operating software on the Aggregator. This chapter contains the following sections: • IGMP Commands • IGMP Snooping Commands IGMP Commands Dell Networking OS supports IGMPv1/v2/v3 and is compliant with RFC-3376. Important Points to Remember • IGMPv2 is the default version of IGMP on interfaces. You can configure IGMPv3 on interfaces. It is backward compatible with IGMPv2. • There is no hard limit on the maximum number of groups supported. • IGMPv3 router interoperability with IGMPv2 and IGMPv1 routers on the same subnet is not supported. • An administrative command (ip igmp version) is added to manually set the IGMP version. • All commands previously used for IGMPv2 are compatible with IGMPv3. ip igmp group-join-limit To limit the number of IGMP groups that can be joined in a second, use this feature. Syntax Parameters ip igmp group-join-limit number number Enter the number of IGMP groups permitted to join in a second. The range is from 1 to 10000. Defaults Command Modes Command History none CONFIGURATION (conf-if-interface-slot/port) Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. ip igmp querier-timeout Change the interval that must pass before a multicast router decides that there is no longer another multicast router that should be the querier. Syntax ip igmp querier-timeout seconds 361