Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 170
management route, Enter an IPv4 address A.B.C.D or the IPv6 address followed
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Defaults Command Modes Command History Usage Information Related Commands interface distance For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter a number as the distance metric assigned to the route. The range is from 1 to 255. Not configured. CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. Using the following example of a static route: ip route 33.33.33.0 /24 tengigabitethernet 0/0 172.31.5.43 • The software installs a next hop that is not on the directly connected subnet but which recursively resolves to a next hop on the interface's configured subnet. In the example, if gig 0/0 has an ip address on subnet 2.2.2.0 and if 172.31.5.43 recursively resolves to 2.2.2.0, Dell Networking OS installs the static route. • When the interface goes down, Dell Networking OS withdraws the route. • When the interface comes up, Dell Networking OS re-installs the route. • When recursive resolution is "broken," Dell Networking OS withdraws the route. • When recursive resolution is satisfied, Dell Networking OS re-installs the route. show ip route - views the switch routing table. management route Configure a static route that points to the Management interface or a forwarding router. Syntax Parameters management route {ipv4-address | ipv6-address}/mask{forwardingrouter-address | managementethernet} {ipv4-address | ipv6-address}/ mask forwardingrouter-address Enter an IPv4 address (A.B.C.D) or the IPv6 address followed by the prefix-length for the IP address of the management interface. Enter an IPv4 address of a forwarding router. managementet hernet Enter the keyword managementethernet for the Management interface. Defaults Command Modes Not configured. CONFIGURATION 170