Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 419
Syntax, Parameter, Unit number, Defaults, Command, Modes, History, Version 9.6., Usage, Information
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 419 highlights
• show system stack-ports • show system stack-unit stack-group • stack-unit iom-mode power-cycle stack-unit To hard reset any stack unit including master unit. Syntax power-cycle stack-unit unit-number Parameter Unit number The unit number ranges from 0 to 5. Defaults Command Modes Command History None EXEC Privilege Version 9.6. (0.0) Supported on the FN I/O Aggregator. Usage Information This command is supported on the FN410S and the FN410T Aggregators. This command is used to reset the stack-unit. The master unit can also be power cycled using this command. reset stack-unit Reset any designated stack member except the management unit (master unit). Syntax reset stack-unit 0-5 hard Parameters 0-5 Enter the stack member unit identifier of the stack member to reset. hard Reset the stack unit if the unit is in a problem state. Defaults Command Modes Command History none EXEC Privilege Version 9.6. (0.0) Supported on the FN I/O Aggregator. Usage Information This command is supported on the FN410S and the FN410T Aggregators Resetting the management unit is not allowed and an error message displays if you try to do so. Resetting is a soft reboot, including flushing the forwarding tables. You can run this command directly on the stack standby unit (Standby Master) to reset the standby. You cannot reset any other unit from the standby unit 419