Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 449
downstream auto-recover
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 449 highlights
Parameters Defaults Command Modes Command History Usage Information interface Enter one of the following interface types: • 10 Gigabit Ethernet: tengigabitethernet {slot/ port |slot/port-range} • Port channel: port-channel {1-512 | portchannel-range} Where port-range and port-channel-range specify a range of ports separated by a dash (-) and/or individual ports/port channels in any order; for example: tengigabitethernet 1/1-2,5,9,11-12 portchannel 1-3,5. A comma is required to separate each port and port-range entry. none UPLINK-STATE-GROUP Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. You can assign physical port or port-channel interfaces to an uplink-state group. You can assign an interface to only one uplink-state group. Configure each interface assigned to an uplink-state group as either an upstream or downstream interface, but not both. You can assign individual member ports of a port channel to the group. An uplinkstate group can contain either the member ports of a port channel or the port channel itself, but not both. Related Commands • upstream - assigns a port or port-channel to the uplink-state group as an upstream interface. • uplink-state-group - creates an uplink-state group and enables the tracking of upstream links. downstream auto-recover Enable auto-recovery so that UFD-disabled downstream ports in an uplink-state group automatically come up when a disabled upstream port in the group comes back up. Syntax downstream auto-recover To disable auto-recovery on downstream links, use the no downstream autorecover command. Defaults The auto-recovery of UFD-disabled downstream ports is enabled. 449