Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 163
speed (for 1000/10000 interfaces), tdr-cable-test
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
speed (for 1000/10000 interfaces) Set the speed for 1000/10000 Base-T Ethernet interfaces. Both sides of a link must be set to the same speed (1000/10000) or to auto or the link may not come up. Syntax speed {1000 | 10000 | auto} To return to the default setting, use the no speed {1000 | 10000 |auto} command. Parameters Defaults Command Modes Command History Usage Information 1000 10000 auto auto INTERFACE Enter the keyword 1000 to set the interface's speed to 1000 Mb/s. Enter the keyword 10000 to set the interface's speed to 10000 Mb/s. Auto-negotiation is enabled. For more information, refer to name Enter the keyword auto to set the interface to autonegotiate its speed. Auto-negotiation is enabled. For more information, refer to name. Version 9.4(0.0) Supported on the FN I/O aggregator. This command is found on the 1000/10000 Base-T Ethernet interfaces. When you enable auto, the system performs and automatic discovery to determine the optics installed and configure the appropriate speed. When you configure a speed for the 1000/10000 interface, confirm the negotiation auto command setting. Both sides of the link must should have auto-negotiation either enabled or disabled. For speed settings of 1000 or auto, the software sets the link to auto-negotiation and you cannot change that setting. In Dell Networking OS, the command speed 1000 is an exact equivalent of speed auto 1000 in IOS. Related Commands negotiation auto - enables or disables auto-negotiation on an interface. tdr-cable-test Test the condition of copper cables on 100/1000/10GBase-T modules. Syntax tdr-cable-test interface 163