Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 445
storm-control broadcast (Interface), Defaults, Command, Modes, History, Version 9.40.0, Syntax
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 445 highlights
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. Defaults Command Modes Command History none • EXEC • EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. storm-control broadcast (Interface) Configure the percentage of broadcast traffic allowed on an interface. Syntax storm-control broadcast [packets_per_second in] To disable broadcast storm control on the interface, use the no storm-control broadcast [packets_per_second in] command. Parameters packets_per_se cond Enter the packets per second of broadcast traffic allowed into the network. The range is from 0 to 33554368. Command Modes Command History Usage Information INTERFACE (conf-if-interface-slot/port) Version 9.4(0.0) Supported on the FN I/O aggregator. This command is available only in PMUX mode. storm-control multicast (Interface) Configure the percentage of multicast traffic allowed on the interface. Syntax storm-control multicast packets_per_second in To disable multicast storm control on the interface, use the no storm-control multicast packets_per_second in command. Parameters packets_per_se cond Enter the packets per second of broadcast traffic allowed into the network. The range is from 0 to 33554368. Command Modes INTERFACE (conf-if-interface-slot/port) 445