Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 418

Command Modes Command History Usage Information CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. The key configured on the switch must match the key configured on the RADIUS server daemon. If you configure the key parameter in the radius-server host command, the key configured with the radius-server key command is the default key for all RADIUS communications. Related Commands radius-server host - configures a RADIUS host. show privilege View your access level. Syntax Command Modes show privilege • EXEC • EXEC Privilege Command History Example Version 9.4(0.0) Supported on the FN I/O aggregator. Dell#show privilege Current privilege level is 15 Dell# Stacking Commands Stacking is supported on the FN410S and FN410T cards with ports 9 and 10 as the stack ports. Stacking is limited to six Aggregators in the same or different chassis in a single stack. Stacking provides a single point of management and NIC teaming for high availability and higher throughput. To configure an Aggregator stack, you must use the CLI. The stacking commands are always available and operational. You can use the commands to preconfigure an Aggregator, so that the configuration settings are invoked when the Aggregator is attached to other Aggregator blades. For more information about using the Aggregator stacking feature, refer to the Stacking Aggregators chapter in the Dell Networking OS Configuration Guide for the FN I/O Aggregator. You can use the following commands to manage a stack of Aggregator I/O modules: • power-cycle stack-unit • reset stack-unit 418