Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 457
peer-link port-channel, show vlt mismatch, Syntax, Parameters, peer-down, Defaults, Command, Modes
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 457 highlights
peer-link port-channel Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain. Syntax peer-link port-channel port-channel-number {peer-down-vlan vlan id} Parameters port-channelnumber Enter the port-channel number that acts as the interconnect trunk. peer-downvlan vlan id Enter the keyword peer-down-vlan then a VLAN ID to configure the VLAN that the VLT peer link uses when the VLT peer is down. Defaults Command Modes Command History Usage Information Not configured. VLT DOMAIN Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. To configure the VLAN from where the VLT peer forwards packets received over the VLTi from an adjacent VLT peer that is down, use the peer-down-vlan parameter. When a VLT peer with bare metal provisioning (BMP) is booting up, it sends untagged DHCP discover packets to its peer over the VLTi. To ensure that the DHCP discover packets are forwarded to the VLAN that has the DHCP server, use this configuration. show vlt mismatch Display mismatches in VLT parameters. Syntax show vlt mismatch Command Modes EXEC Command History Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Example Dell#show vlt mismatch Domain ----------- Parameters Local ------------ ----------- Unit-ID 0 Peer --------- 15 Vlan-config ------------ Vlan-ID Local Mode Peer Mode 100 -- L3 457