Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 305

Related Commands consists of 802.1p priority values that are grouped together for similar bandwidth allocation and scheduling, and that share latency and loss requirements. All 802.1p priorities mapped to the same queue must be in the same priority group. Repeat the priority-group bandwidth pfc command to configure PFC and ETS traffic handling for each priority group in a DCB map. You can enable PFC on a maximum of two priority queues. If you configure more than one priority group as strict priority, the higher numbered priority queue is given preference when scheduling data traffic. If a priority group does not use its allocated bandwidth, the unused bandwidth is made available to other priority groups. To remove a priority-group configuration in a DCB map, enter the no prioritygroup bandwidth pfc command. By default, equal bandwidth is assigned to each dot1p priority in a priority group. Use the bandwidth parameter to configure the bandwidth percentage assigned to a priority group. The sum of the bandwidth allocated to all priority groups in a DCB map must be 100% of the bandwidth on the link. You must allocate at least 1% of the total port bandwidth to each priority group. dcb-map - Creates a DCB map to configure PFC and ETS parameters and applies the PFC and ETS settings on Ethernet ports. priority-pgid - Configures the 802.1p priority traffic in a priority group for a DCB map. priority-pgid Assign 802.1p priority traffic to a priority group in a DCB map. Syntax Parameters priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_groupnum dot1p3_group-num dot1p4_group-num dot1p5_group-num dot1p6_group-num dot1p7_group-num dot1p0_groupnum Enter the priority group number for each 802.1p class of traffic in a DCB map. dot1p1_groupnum dot1p2_groupnum dot1p3_groupnum dot1p4_groupnum 305