Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 299
dcb-map stack-unit all stack-ports all, Command, Modes, History, Version 9.60.0, Usage, Information
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 299 highlights
Command Modes Command History Usage Information Related Commands CONFIGURATION INTERFACE Version 9.6(0.0) Version 9.3(0.0) Supported on the FN I/O Aggregator Introduced on the FC Flex IO module installed in the M I/O Aggregator. A DCB map is a template used to configure DCB parameters and apply them on converged Ethernet interfaces. DCB parameters include priority-based flow control (PFC) and enhanced traffic selection (ETS). To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map command. Use the dcb-map command to create a DCB map to specify PFC and ETS settings and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is enabled on Ethernet ports by default. The dcb-map command is supported only on physical Ethernet interfaces. To remove a DCB map from an interface, enter the no dcb-map map-name command in Interface configuration mode. show qos dcb-map- Displays the dcb-map profiles configured on the system. dcb-map stack-unit all stack-ports all-Applies a DCB map on all ports of a switch stack. dcb-map stack-unit all stack-ports all Apply the specified DCB map on all ports of the switch stack. Syntax dcb-map stack-unit all stack-ports all dcb-map-name To remove the PFC and ETS settings in a DCB map from all stack units, use the no dcb-map stack-unit all stack-ports all command. Parameters dcb-mapname Enter the name of the DCB map. Defaults Command Modes Command History None CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. 299