Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 208
show qos dot1p-queue-mapping, Field, Description, State, PFC Mode, Priorities, Example, Related
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
Example Related Commands Field State PFC Mode PG TSA BW PFC Priorities Description Complete: All mandatory DCB parameters are correctly configured. In progress: The DCB map configuration is not complete. Some mandatory parameters are not configured. PFC configuration in DCB map: On (enabled) or Off. Priority group configured in the DCB map. Transmission scheduling algorithm used by the priority group: Enhanced Transmission Selection (ETS). Percentage of bandwidth allocated to the priority group. PFC setting for the priority group: On (enabled) or Off. 802.1p priorities configured in the priority group. Dell# show qos dcb-map dcbmap2 State :Complete PfcMode:ON PG:0 TSA:ETS BW:50 PFC:OFF Priorities:0 1 2 4 5 6 7 PG:1 TSA:ETS BW:50 PFC:ON Priorities:3 dcb-map - creates a DCB map to configure PFC and ETS parameters and applies the PFC and ETS settings on Ethernet ports. show qos dot1p-queue-mapping View dot1p to queue mapping. Syntax Defaults Command Modes show qos dot1p-queue-mapping none • EXEC • EXEC Privilege Command History Example Version 9.4(0.0) Supported on the FN I/O aggregator. Dell#show qos dot1p-queue-mapping Dot1p Priority : 0 1 2 3 4 5 6 7 Queue : 0 0 0 1 2 3 3 3 Dell# 208