Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 165
vlan untagged (CMC), Example, Related, Commands, Syntax, Parameters, Defaults, Modes, History
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
Example Related Commands For example, if port 0/1-32 is an untagged member of VLAN 2 and port 0/41 is an untagged member of VLAN 3, the resulting LAG consisting of the two ports is an untagged member of VLAN 2 and a tagged member of VLAN3. Dell(conf-if-te-0/2)#vlan tagged ? VLAN-RANGE Comma/Hyphen separated VLAN ID set Dell(conf-if-te-0/2)#vlan tagged 2,3-4 Dell(conf-if-te-0/2)#show config ! interface TenGigabitEthernet 0/2 mtu 12000 vlan tagged 2-4 ! port-channel-protocol LACP port-channel 1 mode active ! protocol lldp advertise management-tlv system-name dcbx port-role auto-downstream no shutdown Dell(conf-if-te-0/2)# interface vlan - Configures a VLAN. vlan untagged - Specifies which interfaces in a VLAN are untagged. vlan untagged (CMC) Add a Layer 2 interface to a VLAN as an untagged interface. Syntax vlan untagged [vlan-id] To remove a untagged interface from a VLAN, use the no vlan untagged [vlan-id] command. Parameters vlan-id Enter the VLAN ID. The range is from 1 to 4094. Defaults Command Modes Command History Usage Information All interfaces in Layer 2 mode are untagged. INTERFACE Version 9.4(0.0) Supported on the FN I/O aggregator. Untagged interfaces can only belong to one VLAN. In the default VLAN, you cannot use the no untagged interfacecommand. To remove an untagged interface from all VLANs, including the default VLAN, enter INTERFACE mode and use the no vlan taggedcommand. 165