Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 256
stack-unit renumber, Syntax, Parameters, Defaults, Command, Modes, History, Version 9.6., Usage
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 256 highlights
stack-unit renumber Change the stack member ID of any stack member or a stand-alone unit. Syntax Parameters stack-unit 0-5 renumber 0-5 0-5 The first instance of this value is the stack member unit identifier, from 0 to 5, of the switch that you want add to the stack. The range is from 0 to 5. The second instance of this value is the desired new unit identifier number. Defaults Command Modes Command History none EXEC Privilege Version 9.6. (0.0) Supported on the FN I/O Aggregator Usage Information This command is supported on the FN410S and the FN410T Aggregators. You can renumber any switch, including the management unit or a stand-alone unit. You cannot renumber a unit to a number of an active member in the stack. When executing this command on the master, the stack reloads. When the members are renumbered, only that specific unit is reset and comes up with the new unit number. Example Related Commands Dell#stack-unit 5 renumber 4 Renumbering will reset the unit. Warning: Interface configuration for current unit will be lost! Proceed to renumber [confirm yes/no]: • reload - reboots Dell Networking Operating System (OS). • reset stack-unit - resets the designated S-Series stack member. • show system - displays the current status of all stack members or a specific member. 256