Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 249
Stacking Commands, power-cycle stack-unit - blade chassis
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 249 highlights
24 Stacking Commands Stacking is supported on the FN410S and FN410T cards with ports 9 and 10 as the stack ports. Stacking is limited to six Aggregators in the same or different chassis in a single stack. Stacking provides a single point of management and NIC teaming for high availability and higher throughput. To configure an Aggregator stack, you must use the CLI. The stacking commands are always available and operational. You can use the commands to preconfigure an Aggregator, so that the configuration settings are invoked when the Aggregator is attached to other Aggregator blades. For more information about using the Aggregator stacking feature, refer to the Stacking Aggregators chapter in the Dell Networking OS Configuration Guide for the FN I/O Aggregator. You can use the following commands to manage a stack of Aggregator I/O modules: • power-cycle stack-unit • reset stack-unit • show system stack-ports • show system stack-unit stack-group • stack-unit iom-mode power-cycle stack-unit To hard reset any stack unit including master unit. Syntax Parameter power-cycle stack-unit unit-number Unit number The unit number ranges from 0 to 5. Defaults Command Modes Command History None EXEC Privilege Version 9.6. (0.0) Supported on the FN I/O Aggregator. Usage Information This command is supported on the FN410S and the FN410T Aggregators. 249