Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 61
show cpu-traffic-stats, Example, Syntax, Parameters, Defaults, Command, Modes, History, Version 9.40.0
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Example entering CONFIGURATION mode. Rollback indicates that Dell Networking OS is in a rollback process. The line number shown in the output can be used to send the messages to that session or release a lock on a VTY line. Dell#show configuration lock Configure exclusively locked by the following line: Line : vty 0 Line number : 2 User : admin Type : AUTO State : LOCKED Ip address : 10.11.9.97 Dell# show cpu-traffic-stats Display the CPU traffic statistics. Syntax Parameters show cpu-traffic-stats [port number | all] port number (OPTIONAL) Enter the port number to display traffic statistics on that port only. The range is from 1 to 1568. all (OPTIONAL) Enter the keyword all to display traffic statistics on all the interfaces receiving traffic, sorted based on the traffic. Defaults Command Modes Command History Usage Information Example all EXEC Version 9.4(0.0) Supported on the FN I/O aggregator. Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is displayed first. All CPU and port information is displayed unless a specific port or CPU is specified. Traffic information is displayed for router ports only; not for management interfaces. The traffic statistics are collected only after the debug cpu-traffic-stats command is executed; not from the system bootup. NOTE: After debugging is complete, use the no debug cpu-trafficstats command to shut off traffic statistics collection. Dell#show cpu-traffic-stats Processor : CP Received 100% traffic on TenGigabitEthernet 0/2 Total packets:100 LLC:0, SNAP:0, IP:100, ARP:0, other:0 Unicast:100, Multicast:0, Broadcast:0 Dell# 61