Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 369
Layer 2, MAC Addressing Commands, mac-address-table aging-time, Last Change
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 369 highlights
Last Change ----------- ----------*S 0.0.0.0/0 3d2h Dell# ------via 10.10.91.9, Te 1/2 ----------1/0 Layer 2 This chapter describes commands to configure Layer 2 features. This chapter contains: • MAC Addressing Commands MAC Addressing Commands The following commands are related to configuring, managing, and viewing MAC addresses. mac-address-table aging-time Specify an aging time for MAC addresses to remove from the MAC address table. Syntax Parameters mac-address-table aging-time seconds To delete the configured aging time, use the no mac-address-table agingtime seconds command. seconds Enter either zero (0) or a number as the number of seconds before MAC addresses are relearned. To disable aging of the MAC address table, enter 0. The range is from 10 to 1000000. The default is 1800 seconds. Defaults Command Modes Command History 1800 seconds CONFIGURATION Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. mac-address-table static Associate specific MAC or hardware addresses to an interface and virtual local area networks (VLANs). Syntax mac-address-table static mac-address output interface vlan vlan-id To remove a MAC address, use the no mac-address-table static macaddress output interface vlan vlan-id command. 369