Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 374
lacp port-priority, port-channel mode, Syntax, Parameters, Defaults, Command, Modes, History
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 374 highlights
lacp port-priority To influence which ports will be put in Standby mode when there is a hardware limitation that prevents all compatible ports from aggregating, configure the port priority. Syntax lacp port-priority priority-value To return to the default setting, use the no lacp port-priority priorityvalue command. Parameters Defaults Command Modes Command History priority-value 32768 INTERFACE Enter the port-priority value. The higher the value number, the lower the priority. The range is from 1 to 65535. The default is 32768. Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. port-channel mode Configure the LACP port channel mode. Syntax Parameters port-channel number mode [active] [passive] [off] number active Enter the keywords number then a number. Enter the keyword active to set the mode to the active state. NOTE: LACP modes are defined in Usage Information. passive Enter the keyword passive to set the mode to the passive state. NOTE: LACP modes are defined in Usage Information. off Enter the keyword off to set the mode to the off state. NOTE: LACP modes are defined in Usage Information. Defaults Command Modes Command History off INTERFACE Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. 374