Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 376
advertise dot3-tlv, advertise management-tlv, Length, Value.
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 376 highlights
The starting point for using LLDP is invoking LLDP with the protocol lldp command in either CONFIGURATION or INTERFACE mode. The information LLDP distributes is stored by its recipients in a standard management information base (MIB). You can access the information by a network management system through a management protocol such as simple network management protocol (SNMP). For details about implementing LLDP/LLDP-MED, refer to the Link Layer Discovery Protocol chapter of the Dell Networking OS Configuration Guide. advertise dot3-tlv Advertise dot3 TLVs (Type, Length, Value). Syntax advertise dot3-tlv {max-frame-size} To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-framesize} command. Parameters max-framesize Enter the keywords max-frame-size to advertise the dot3 maximum frame size. Defaults Command Modes Command History none CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Version 9.4(0.0) Supported on the FN I/O aggregator. This command is supported in Programmable-Mux (PMUX) mode only. advertise management-tlv Advertise management TLVs (Type, Length, Value). Syntax advertise management-tlv {system-capabilities | systemdescription | system-name} To remove advertised management TLVs, use the no advertise managementtlv {system-capabilities | system-description | system-name} command. Parameters systemcapabilities systemdescription system-name Enter the keywords system-capabilities to advertise the system capabilities TLVs to the LLDP peer. Enter the keywords system-description to advertise the system description TLVs to the LLDP peer. Enter the keywords system-name to advertise the system name TLVs to the LLDP peer. Defaults none 376