Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 171
show arp, Hardware Address
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
Command History Usage Information Version 9.4(0.0) Supported on the FN I/O aggregator. When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol route) is preferred over the Management Static route. Also, Management static routes and the Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4 management routes. This command manages both tables. show arp Displays the ARP table. Syntax Parameters show arp [interface interface ] [dynamic] [summary] interface interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For the Management interface, enter the keyword managementethernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. dynamic summary (OPTIONAL) Enter the keyword dynamic to view dynamic entries. (OPTIONAL) Enter the keyword summary to view a summary of ARP entries. Command Modes Command History Usage Information EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. The following describes the show arp command shown in the following example. Row Heading Description Protocol Displays the protocol type. Address Displays the IP address of the ARP entry. Age(min) Displays the age (in minutes) of the ARP entry. Hardware Address Displays the MAC address associated with the ARP entry. Interface Displays the first two letters of the interfaces type and the slot/port associated with the ARP entry. VLAN Displays the VLAN ID, if any, associated with the ARP entry. 171