Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Command Line Reference Gui - Page 152
show interfaces description, Multicasts, 0 Broadcasts, 0 Unicasts
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
0 packets, 0 bytes 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts 0 runts, 0 giants, 0 throttles 0 CRC, 0 overrun, 0 discarded Output Statistics: 0 packets, 0 bytes, 0 underruns 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 throttles, 0 discarded, 0 collisions, 0 wreddrops Rate info (interval 299 seconds): Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Time since last interface status change: 05:14:12 TenGigabitEthernet 0/2 is up, line protocol is down(errordisabled[UFD]) Dell# show interfaces description Display the descriptions configured on the interface. Syntax Parameters show interfaces [interface] description interface Enter one of the following keywords and slot/port or number information: • For the management interface on the stack unit enter the keyword ManagementEthernet followed by the slot/ port information. The slot range is 0-0 and the port range is 0. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For VLAN interfaces, enter the keyword vlan followed by a number from 1 to 4094. Command Modes Command History Usage Information • EXEC • EXEC Privilege Version 9.4(0.0) Supported on the FN I/O aggregator. The following describes the show interfaces description command shown in the Example below. 152