ZyXEL NAS540 User Guide - Page 186
PPPoE Screen
View all ZyXEL NAS540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
Chapter 9 Network Table 47 Network > UPnP > Port Mapping (continued) LABEL WAN Port DESCRIPTION When you enable WAN access for one of the NAS's services, specify the port number (1~65,536) Internet uses need to use to connect to the Internet gateway's WAN port in order to access the service on the NAS. Whoever wants to access a service on the NAS from the Internet must use this port number. P2P download's WAN port must be the same as the LAN port. Make sure there is not another service using TCP protocol with the same port number. Apply Reset If another device is using the same port (the Internet gateway has the same port number mapped to another LAN IP address), the NAS overwrites it when you apply the setting and WAN users can no longer access the other device. This icon means the service's LAN and WAN port numbers must be the same. This icon means another service is using the same port number as this service. Change the port number of one of the services so they use different port numbers. This icon means another service is using the listed port, but the port the other service is using will be replaced if you apply the setting. The other service will no longer be accessible from the listed port. Click Apply to save your changes back to the NAS. Click Reset to begin configuring this screen afresh. 9.6 PPPoE Screen Use this screen to configure PPPoE settings for a direct Internet connection. Click Network > PPPoE in the navigation panel to open the following screen. Figure 86 Network > PPPoE 186 NAS540 User's Guide