HP StorageWorks 2/16V Brocade Web Tools Administrator's Guide (53-0000194-01, - Page 125
Managing FCIP Tunnels, To edit an IP route
View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
7 To edit an IP route 1. Click a port in the Switch View to launch the Port Management module in a separate window (see Figure 5-1 on page 5-2). 2. Click the GigE Ports subtab. 3. Click the port you want to edit and click the IP Routes subtab. 4. Select the IP route to edit in the table on the right side of the window. 5. Click Edit in the task bar. The Edit IP Route dialog box displays, populated with the current configuration values. Retype the metric for the IP Route. 6. Click OK. Note Before you can delete an IP route, you must first delete the corresponding FCIP tunnel. To delete an IP route 1. Click a port in the Switch View to launch the Port Management module in a separate window (see Figure 5-1 on page 5-2). 2. Click the GigE Ports tab and click the port you want to edit. 3. Click the IP Routes subtab. 4. Select the IP route to delete in the table on the right side of the window. Use Shift-click and Ctrl- click to select multiple IP routes. 5. Click Delete in the task bar. 6. Click Yes in the confirmation window. Managing FCIP Tunnels To configure FCIP tunnels, you must specify the following attributes: • IP address of the remote switch • IP address of the local interface • Whether the tunnel rate is uncommitted or committed and, if committed, the committed rate for the tunnel Uncommitted rate tunnels use a minimum of 1000 Kb/sec, up to a maximum of the available uncommitted bandwidth on the GbE port. • (Optional) WWN of the remote switch • Whether compression, fastwrite, tape pipelining, or an IKE/IPSec policy is enabled or disabled. These are all features of FCIP. Web Tools Administrator's Guide Publication Number: 53-0000194-01 7-15