HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 102
Replacing a Hard Disk Drive, Open the right door of the bezel on the workstation's front panel.
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Field Replaceable Units (FRUs) FRU Removal and Replacement Replacing a Hard Disk Drive: NOTE If you are installing a new hard disk drive, the T-15 Torx screws for attaching the drive in the bracket are stored on the bracket rails. Also see "Hard Disk Drive Configuration" on page 36 for information about configuring a hard disk drive for installation. 1. Open the right door of the bezel on the workstation's front panel. 2. Perform the previous removal procedure in reverse order. NOTE To verify a good connection with the SCA hard disk interface (backplane board) connector, press firmly on the outside corners of the bracket. 98 Chapter 4
98
Chapter 4
Field Replaceable Units (FRUs)
FRU Removal and Replacement
Replacing a Hard Disk Drive:
NOTE
If you are installing a new hard disk drive, the T-15 Torx screws for attaching
the drive in the bracket are stored on the bracket rails. Also see “Hard Disk
Drive Configuration” on page 36 for information about configuring a hard
disk drive for installation.
1.
Open the right door of the bezel on the workstation’s front panel.
2.
Perform the previous removal procedure in reverse order.
NOTE
To verify a good connection with the SCA hard disk interface (backplane
board) connector, press firmly on the outside corners of the bracket.